Experimental verification of dependence of the cutting forces prediction accuracy on the uncut chip cross section modeling in turning

Dominika Śniegulska-Graodzka , Mirosław Nejman , Krzysztof Jemielniak

Abstract

Simulation of machining is increasingly becoming an indispensable tool in the process of production preparation. At the same time, more and more complex models of the division of the uncut chip cross section in determining of the cutting forces are being observed, which does not necessarily increase the reliability of the results. This article introduces the cutting force modeling, which uses a variety of methods to divide the uncut chip cross section into segments that correspond to a straight and curvilinear cutting edge. The results were verified by measuring the modeled cutting forces during turning with different insert geometries.

Author Dominika Śniegulska-Graodzka - [Politechnika Warszawska]
Dominika Śniegulska-Graodzka,,
-
-
, Mirosław Nejman (FPE / IoMP)
Mirosław Nejman,,
- The Institute of Manufacturing Processes
, Krzysztof Jemielniak (FPE / IoMP)
Krzysztof Jemielniak,,
- The Institute of Manufacturing Processes
Journal seriesProcedia CIRP , ISSN 2212-8271, (0 pkt)
Issue year2019
Vol79
Pages51-56
DOIDOI:10.1016/j.procir.2019.02.010
Languageen angielski
Score (nominal)5
ScoreMinisterial score = 5.0, 12-06-2019, ArticleFromJournal
Publication indicators Scopus Citations = 0
Citation count*
Cite
Share Share

Get link to the record


* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Back