Accuracy of the Parts from Iron Powder Manufactured by Injection Moulding

Andrzej Skalski , Dionizy Biało

Abstract

This paper presents the results of investigation on the influence of injection moulding conditions on the challenge of the element diameters after injection and after sintering. The feedstock composed of iron powders with granularity of 1 and 4 µm and special thermoplastic binder based on paraffin, wax, polyethylene and stearic acid were used. The paper looks at the influence of powder content Vp and powder granularity on shrinkage and spread of the element diameters. As the indicating parameter of element accuracy standard deviation was selected.
Author Andrzej Skalski (FM / IMBE)
Andrzej Skalski,,
- The Institute of Metrology and Biomedical Engineering
, Dionizy Biało (FM / IMBE)
Dionizy Biało,,
- The Institute of Metrology and Biomedical Engineering
Pages261-266
Publication size in sheets0.5
Book Jabłoński Ryszard, Březina Tomáš (eds.): Advanced Mechatronics Solutions, Advances in Intelligent Systems and Computing, 2016, Springer, ISBN 978-3-319-23921-7, 668 p., DOI:10.1007/978-3-319-23923-1
Keywords in Englishinjection moulding iron powder shrinkage accuracy
DOIDOI:10.1007/978-3-319-23923-1_39
URL http://link.springer.com/chapter/10.1007/978-3-319-23923-1_39
Languageen angielski
Score (nominal)0
Score sourcejournalList
ScoreMinisterial score = 0.0, 30-01-2020, BookChapterSeriesAndMatConfByIndicator
Ministerial score (2013-2016) = 0.0, 30-01-2020, BookChapterSeriesAndMatConfByIndicator
Publication indicators WoS Citations = 0; Scopus Citations = 1
Citation count*
Cite
Share Share

Get link to the record


* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Back
Confirmation
Are you sure?