Active narrowband filter based on inductance and capacitance for low-frequency applications

Aleksander Burd , Mariusz Jarosław Suchenek

Abstract

Most analog filter solutions operating in the kilohertz frequency range are based on RC elements. However, it is not possible to design a verynarrow filter (high q-factor around 1000) by using this architecture. In this article, we would like to show a filter implemented based on asimple series LC resonance circuit (consisting of just an inductor and a capacitor) and an analog circuit. The designed filter based on theseelements can be more selective than a typical active filter based on RC elements (resistor and capacitor). Performed measurements confirmed the correct operation of the filter, where the designed filter q-factor was∼591 at a resonant frequency of 4.73 kHz.
Author Aleksander Burd (FEIT / PE)
Aleksander Burd,,
- The Institute of Electronic Systems
, Mariusz Jarosław Suchenek (FEIT / PE)
Mariusz Jarosław Suchenek,,
- The Institute of Electronic Systems
Journal seriesReview of Scientific Instruments, ISSN 0034-6748, e-ISSN 1089-7623
Issue year2020
Vol91
No2
Pages1-4
Publication size in sheets1305.15
ASJC Classification3105 Instrumentation
DOIDOI:10.1063/1.5116657
URL https://aip.scitation.org/doi/10.1063/1.5116657
Languageen angielski
Score (nominal)70
Score sourcejournalList
ScoreMinisterial score = 70.0, 17-06-2020, ArticleFromJournal
Publication indicators Scopus Citations = 0; Scopus SNIP (Source Normalised Impact per Paper): 2016 = 0.855; WoS Impact Factor: 2018 = 1.587 (2) - 2018=1.582 (5)
Citation count*
Cite
Share Share

Get link to the record


* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Back
Confirmation
Are you sure?