Measurement of extremely long microbores by application of laser metrology

Ryszard Jabłoński

Abstract

The measurement information contained in a very narrow laser beam penetrating a microbore is distorted depending on the microbore geometry. The presented research is composed of three stages: design and experiments on the single lens and double lens laser beam shaping system, the measurement of trough bores and interferometric measurement of blind bores with reflective bottom. The samples were prepared from glass–resin laminate (some of metal plates) with microbore diameter ranging from 25 μm to 200 μm and set coaxially in piles. The paper describes the properties (power loss and phase distortion) of a focused laser beam penetrating long microbores. As a reference a microbore of diameter d=100 μm was taken and all comparative results presented without close description refer to this value. The experiments proved the advantage of a single lens laser beam shaping system and confirmed the possibility of application of interferometric measurement of blind bores.
Author Ryszard Jabłoński (FM / IMBE)
Ryszard Jabłoński,,
- The Institute of Metrology and Biomedical Engineering
Journal seriesMeasurement, ISSN 0263-2241
Issue year2000
Vol28
No3
Pages139-145
Keywords in EnglishGaussian beam, Microbore, Visibility
ASJC Classification2604 Applied Mathematics; 2208 Electrical and Electronic Engineering; 3104 Condensed Matter Physics; 3105 Instrumentation
DOIDOI:10.1016/S0263-2241(00)00007-5
URL http://www.sciencedirect.com/science/article/pii/S0263224100000075
Score (nominal)25
Score sourcejournalList
Publication indicators WoS Citations = 4; Scopus Citations = 7; Scopus SNIP (Source Normalised Impact per Paper): 2000 = 0.645; WoS Impact Factor: 2006 = 0.525 (2) - 2007=0.571 (5)
Citation count*9 (2015-05-01)
Cite
Share Share

Get link to the record


* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Back
Confirmation
Are you sure?